Stand Assembly & Adjustment; Getting Started - Vornado 533DC Owner's Manual

STAND ASSEMBLY & ADJUSTMENT
(MODEL 683DC)
No tools required.
STAND ASSEMBLY
1. Place the circulator head face down on
the ground on a soft surface.
2. The upper pole and lower pole are
pre-assembled with the Fastening Nut
(D) secured on the underside of the
base. Rotate Fastening Nut counter-
clockwise to remove and set aside.
NOTE: Poles must be
circulator head.
3. Loosen the Adjustment Collar (F) by
gently rotating it counter-clockwise.
Extend the poles by 3-4 inches and
retighten collar.
A
4. Insert power cord (A) into the top of
Pole and pull through the bottom.
NOTE: Do not
overtighten
5. Push the circulator head into the pole. Adjustment
Collar as height
Push until the Lock Release Button (B)
adjustment
snaps through the Hole (C).
could become
6. Assemble Legs onto the base of Pole
by pushing each Leg onto the grooves
(E). Replace Fastening Nut (D) by
rotating clockwise to secure all the
Legs in place.
6
English
HEIGHT ADJUSTMENT
(32 - 38 INCHES)
1. Support the Circulator Head (G) with one hand.
Use your other hand to loosen the Adjustment
Collar (F) by gently rotating it counter-clockwise.
B
2. Slowly raise or lower the Pole to the desired
height and secure into position by rotating the
Adjustment Collar clockwise until tight.
Note: Before adjusting
C
the height or rotating
the head, check that
the power cord is not
E tangled and able to
Loosen
move freely.
F
After adjusting height,
ensure that the
Adjustment Collar is
fully tightened and
engaged to ensure
Circulator Head does
not rotate and bind
power cord.
D

GETTING STARTED

(MODEL 683DC)
CORD CONNECTION
1. Insert DC power cord plug
into port that extends from
the bottom of circulator.
2. Connect the AC power
cord to the power supply.
3. Plug the power cord into
G
a power outlet.
F
VARIABLE SPEED CONTROL
1. Rotate knob to the right to
turn on and increase speed.
2. Rotate knob to left to lower
speed and turn off.
POWER SUPPLY
(24V DC/1.5 AMP)
Note: The external power supply
may become slightly warm to the
touch during normal operation.
English
7