Power Failure - Wahlberg Winch 25 User Manual

LED Functions
DMX LED
The DMX lamp will light steady green when receiving a DMX signal.
The DMX lamp will blink green if no DMX signal is present.
Error LED
The error LED will light red if there is an error.
Reset error is done by toggling the setting DMX channel 4 to 0.
When the Error LED lights red, there will also be an error description in the display.
Errors and error codes:
Winch will not start, display shows nothing.
Winch will not start, DMX lamp is blinking.
The winch will not run, DMX LED is steady
green.
The wire is not wound up on the drum correctly.

Power failure

The winch will stop at power failure. When the power is re-established, the winch has to be reset
before it is ready to use.
It is advisable to set all the DMX channels on 0 % before the power is re-established.
Date: January 19, 2017
805.220.007
Check if the winch is connected to mains power.
Check if the fuse in the winch is blown.
Check DMX signal
Check limit switch inputs are connected.
Check slack detection.
Manually lower the wire totally of the drum,
while controlling that the wire comes out of the
winch nicely. Afterwards the wire is rolled back
onto the drum.
Reset the top position afterwards.
15