Southbend 1184093 Operator's Manual page 37

H -S E C
ALF IZE LECTRIC ONVECTION
INTERPRETING DISPLAYED ERROR CODES
Programmable and Rack Timer models are able to detect some problems that might occur. If the control
panel display is showing a letter "F" followed by a number, consult the following table to determine the
problem and appropriate corrective action.
Symptom Possible Cause
Display shows F1 Bad temperature controller.
Display shows F2 Oven interior maximum temperature
exceeded.
Display shows F3 Open temperature probe.
Display shows F4 Shorted temperature probe.
Display shows F5 Bad temperature controller.
Display shows F6 Bad temperature controller.
Display shows F7 Total cook time in a program exceeds 24
hours (programmable models only).
Display shows F8 Bad temperature controller.
CONTROL PANEL ACCESS AND SHUT-OFF SWITCH
To access the control panel components, remove the screw at the top of the control panel and pull the top
of the control panel out and down (see drawing below). A wiring diagram for the oven is located on the side
of the control panel assembly. When the control panel is folded down, all power to the control panel is
cut off by a shut down switch that is located directly behind and below the control panel. To re-
energize the controls for troubleshooting, pull the white plunger on the shut down switch up.
Accessing Control Panel Components
O
PERATOR
O
VENS
Check or Replace
Replace temperature controller.
Check whether element contactor is stuck shut. If not, replace
temperature controller.
Check connection. If connection is OK, replace probe.
Check probe wires. If wires are not shorted, replace probe.
Replace temperature controller.
Replace temperature controller.
Change program so that total cook time does not exceed 24 hours.
Replace temperature controller.
Location of Wiring Diagram
' M 1184093
S ANUAL
T
ROUBLESHOOTING
Screw
P 37
AGE