KWS Electronic VAROS 106 Manual page 139

Chapter 20 - Measurement Data Recording (DataGrabber) 139
Figure 20-2 DataGrabber recording
The absolute number of packet errors is also displayed in this operating mode.
You can use the ABORT menu item to stop the recording before the specified time period has
elapsed. This only stops the recording. Data that was recorded up until this point remains saved on
the graphics screen.
If the instrument reaches the end of the recording process normally, i.e., without being interrupted,
a beep sounds and the screen like in the next message.
Figure 20-3 Datagrabber recording finished
The RESTART menu item allows you to initiate a new recording process using the same settings.
106 V3.2