Blind/Shutter Mechanism Parameters - Panasonic WRKT4504E Series Reference Manual

Switching/Blind Actuator

4.2.2.2 Blind/Shutter Mechanism Parameters

For blind mechanism, the "Venetian Blind" must be selected and for shutter mechanism, the "Roller
Shutter" must be selected from the "Mode of operation" parameter on the Channel page.
Name
Mode of operation
Complete runtime "Up"
5 ... 500 *x 1sec.]
Complete slat turn
40 ... 250 [x10ms]
Number of steps for a
complete turn
[ x steps]
Send slat feedback
Object step duration
for step/stop [x sec.]
Fabric stretching times
0...59 *x sec.+
Send heignt feedback
Value
Venetian Blind
[40...200...250]
[3...5...12] steps
Yes,only on change
Yes,cyclical and on change
Yes,only on change
Yes,cyclical and on change
Description
This parameter specifies the blind
mechanism.
Roller Shutter
Enter the measured runtime for ascending
[5...50... 500] (in seconds).
Enter the measured turn time of the slats in
increments of 10ms.
100 = 100 x 10ms = 1s
This specifies the number of individual steps
a complete slat turn is to be divided into (3
to 12).
No This parameter
blind/shutter slat level will be sent to the
bus sor not. If yes, the feedback type can be
set according to the values. The cycle time
can be set from the General page.
This specifies whether or not it should be
[1..20] sec. possible to adjust the drive in small steps,
and it also specifies the duration of a single
step.
The fabric stretching function permits
[0...59+ sec. 'smoothing' the fabric of an awning tight
after lowering. See Figure on. "0" value
disable this function.
No This parameter
blind/shutter height level will be sent to the
bus or not. If yes, the feedback type can be
set according to the values. The cycle time
can be set from the General page.
sets whether the
sets whether the
32