Central Switching; Central Continuous On; Central Continuous Off; Feedback Function - Panasonic WRKT4504E Series Reference Manual

Switching/Blind Actuator

4.1.3.5 Central Switching:

With the central switching, the behaviour of the channels is identical with 'normal' activation via the
"Switching" object. If the central switch object is set to "1", the channels which are participated to
central switching are switched on and if it is set to "0" the participated channels are switched off. For
participating a channel to central switch function, this must be specified by the "Participation in central
switch" parameter.

4.1.3.6 Central Continuous ON:

Central continuous ON object is prior to all other objects. This means that if the central continuous
ON object is set to "1" the channels which are participated to central continuous on function are
switched on regardless of all other objects (switch object, central switch object, linking objects...etc).
If the central continuous on object is set to "1", the participated channels stay continuously ON
position and they can not be swithed off until this object is set to "0".

4.1.3.7 Central Continuous OFF:

Central continuous OFF object is prior to all other objects. This means that if the central continuous
OFF object is set to "1" the channels which are participated to central continuous off function are
switched off regardless of all other objects (switch object, central switch object, linking objects...etc).
If the central continuous on object is set to "1", the participated channels stay continuously OFF
position and they can not be swithed on until this object is set to "0". The important point is Central
continuous On object is prior to Central continuous Off object. This means if both of objects are set to
"1" at the same time, the participated channels are switched on continuously.

4.1.3.8 Feedback Function

Feedback object is a 1bit object that sends the channel status to bus. It says to bus the channel status.
For ON position it sends "1" and for OFF position it sends "0" to bus. Each channel has to be
participated to feedback function from the "Sending feedback" parameter. There are five possible
selections in this parameter:
 No : Do not use feedback.
 Yes, only on change, non-inverted: Use feedback only when the channel status is changed
and send the channel status as non-inverted format.
 Yes, cyclical and on change, non-inverted : Use feedback when the channel status is
changed and cyclical and send the channel status as non-inverted format.
 Yes, only on change, inverted: Use feedback only when the channel status is changed and
send the channel status as non-inverted format.
 Yes, cyclical and on change, inverted: Use feedback when the channel status is changed and
cyclical and send the channel status as non-inverted format.
25