Unpacking And Ordering A Vlt Frequency Converter; Type Code Ordering Number String - Danfoss VLT 7000 Series Manual

Unpacking and ordering a VLT frequency converter

If you are in doubt as to which frequency converter
you have received and which options it contains,
use the following to find out.

Type code ordering number string

On the basis of your order, the frequency converter is
given an ordering number that can be seen from the
nameplate on the unit. The number may look as follows:
VLT-7008-B-T4-B20-R3-DL-F00-A33
This means that the frequency converter ordered is a
VLT 7008 for three-phase mains voltage of 380-460 V
(T4) in Bookstyle enclosure IP 20 (B20). The hardware
variant is with integral RFI filter, classes A & B (R3). The
frequency converter features a control unit (DL) without
an option card (F00). Character no. 8 ( B) indicates
the application range of the unit: B = Booster.
Hardware variant
The units in the programme are available in the
following hardware variants:
ST: Standard unit with or without control
unit. Most of the types are with
DC terminals, please see DC bus
connection for exceptions.
RFI filter
Bookstyle units always come with an integral RFI
filter that complies with EN 55011-B with 20 m
screened/armoured motor cable and EN 55011-A1
with 150 m screened/armoured motor cable. Units
for a mains voltage of 380-460 V and a motor
power of up to 7.5 kW (VLT 7011) are always
supplied with an integral class A1 & B filter. Units
for higher motor power can be ordered either with
or without an RFI filter.
Control unit (keypad and display)
All types of units in the programme, can be ordered
either with or without the control unit.
Conformal Coating
All types of units in the programme are available
only with conformal coating of the PCB.
MG.70.A1.02 - VLT is a registered Danfoss trademark
VLT® 7000 Booster
11