Fastening - Siemens SITRANS P310 with HART Compact Operating Instructions

3.3.2 Installation
Note
Damage to measuring cell
When installing the process connection of the pressure transmitter, do not rotate the housing. Rotating the housing may
damage the measuring cell.
To avoid damage to the device, tighten the threaded nuts of the measuring cell using a wrench.
Procedure
Attach the pressure transmitter to the process connection with an appropriate tool.
See also
Introduction to commissioning (Page 23)
3.3.3

Fastening

Fastening without the mounting bracket
You can fasten the pressure transmitter directly to the process connection.
Fastening with the mounting bracket
You can fasten the mounting bracket as follows:
● On a wall or a mounting frame using two screws
● On a vertical or horizontal mounting tube (Ø 50 to 60 mm) using a tube bracket
Fasten the pressure transmitter mounting bracket using the two screws provided.
Figure 3-1 Fastening the pressure transmitter on the mounting bracket
14
SITRANS P310 with HART
A5E35075329-01, 05/2015