Configure Device With Hw Config; Configure Cfc - Siemens SITRANS P Series Supplement To Operating Instructions

PROFIsafe
1.5 PROFIsafe Configuration
1.5.3

Configure device with HW Config

Procedure
1. You are in the "Catalog" view with the "standard" profile. Go to the device in the catalog:
2. Pull the following device onto "PA Master System" with Drag & Drop.
3. Set the PROFIBUS address.
4. Delete the default module of the device at Slot 1.
5. You are now in the "Catalog" view. Under the PROFIsafe device go to the fail-safe
6. Pull the F-module onto Slot 1 with Drag & Drop.
7. Open the "Properties" dialog box of the catalog.
8. Check the PROFIsafe address, parameter "F_Dest_ADD".
9. Close the "Properties" dialog box of the catalog.
10. Click the "Save and compile" button.
11. Press the "Download to module" button.
1.5.4

Configure CFC

Procedure
1. You are in the "Catalog" window, "Libraries" tab.
2. Locate the block "F_PA_AI [FB356] in the "Failsafe Blocks" library.
3. Pull the block into the plan with Drag & Drop.
4. Set the parameter "Value", value type "Real" in the block "F_PA_AI" as follows:
5. Press the "Compile program" button.
1-4
"PROFIBUS-PA > Sensors > Pressure > SIEMENS > SITRANS P DSIII PROFIsafe"
The "Properties" dialog box is opened.
The device is displayed in HW Config with the default configurations.
configuration "F:Pressure\Level\Flow\Temp".
Note:
You must set the PROFIsafe address, parameter "F_Dest_ADD" to the same value later
using the PDM table in the device.
– Click this parameter with the right mouse button.
– Select "Connect to Operand..." in the context menu.
A selection list of transfer rates is displayed.
– Connect the parameter value of the block "F_PA_AI" with the real value of the
configured device.
Supplement to Operating Instructions, 03/2006, A5E00732533-01
SITRANS P, DS III PROFIsafe series