Advertisement
2. Connection
PD4-S1(Single Channel） ：PD-RX（Receiver Motor）connect with the D-Tap Power Cable.
Then, the D-Tap Power Cable connect with V-mount Power Cable.
PD4-S2(Double Channel)：PD-RX（Receiver Motor）and PD-MP（Slave Motor）are
connected by slave motor cable，PD-MP（Slave Motor）connect with the D-Tap Power Cable.
Then, the D-Tap Power Cable connect with V-mount Power Cable.
PD4-S3(Three Channel)：PD-RX (Receive Motor) and PD-MX (Slave Motor) and PD-MP
(Slave Motor) are connected by two parts of slave cables. PD-MP (Salve Motor) connects with
the D-Tap power cable, and the D-tap power cable connects with V-mount power supply. 7-20V
interface on the motor is used for power supply and signal transmission, it can be connected
according to the most convenient location.
Instruction Manuals
3. Powering on (turn on the controller and the motor)
Press the ON/OFF button on the right side of the controller for three seconds, until the screen is
bright and then loosen the button. The motor does not need to turn on or turn off, it will turn on
automatically when power supply. It will turn off automatically when outage.
4. Set up the signal channel, the motor connects to controller.
Check the info at the OLED monitor on the controller and master motor to see if they are at
the same signal channel. In case of inconsistency, you can adjusted the controller or the signal
channel of the motor. check whether is the signal lattice on the top of right screen or not when
the signal channel is consensus. If there has an indication, that has been successfully
connected.
1. Check the consistency
of the channel number.
The Slave Motor Cable
PD-RX
PD-MX
(Receive Motor
（Slave Motor
）
Set Up
The Slave Motor Cable
PD-MP
Motor）
（Slave
）
2. Check signal
intensity.
D-Tap Power Cable
Advertisement
