Hirose Wiring For Sony Bodypacks - Shure TwinPlex TH53-MTQC User Manual

Hirose Wiring for Sony Bodypacks

Notes:
• When using TwinPlex mics with Sony Hirose 4­pin bodypacks, Shure recommends purchasing Shure –MTQG versions
and not –NC versions. This facilitates an easier termination due to the lack of circuitry required in Shure 3­wire/MTQG
TA4F products.
• Due to the thin cable on TwinPlex and the large boot on Hirose connectors, heat shrink may be required to build up the ca­
ble under the boot where the crimp connection is made and where the cable exits the boot
• The TwinPlex Microdot (-MDOT) version can be used with 4-pin Hirose adapters from DPA (DPA part # DAD6008)
Cable
Electri­
Con­
Series cal De­
struc­
sign
tion
1.6mm
cable
with 2
TH53-
con­ 2-Wire
LEMO
duc­ (Com­
TH53- tors, 2 mon
NC shield Source)
wires
and
shield
1.6mm
cable
with 2
con­ 3-Wire
TH53- duc­ (Source
MTQG tors, 2 Follow­
shield er)
wires
and
shield
Polari­ Replacement For Use
ty Connector With
Nega­
tive
with Sony Hirose
Hirose 4-pin-
re­ Bodypacks
KMC-9BPD-4P
spect (WRT)
to
ground
Posi­
tive
with Sony Hirose
Hirose 4-pin-
re­ Bodypacks
KMC-9BPD-4P
spect (WRT)
to
ground
Line Art (From Solder
Wiring
Side)
Red wire: Audio/Bias:
Into resistor and ca­
pacitor
1: 8.2k resistor
2: Jumper to 4
3: 1 uF capacitor (-)
4: Ground/shield-
jumper to 2
Split Shield to shell
Blue wire: not used
1: Red wire (Bias)
2: Blue wire (Audio)
3: Jumper to 4
4: Ground/shield-
jumper to 3
Split Shield to shell
Shure Incorporated
13/17