Shure Incorporated Table of Contents Specifications BRH440M BRH441MBroadcast Headset Microphone Headphone LIMITED WARRANTY Service Centers Accessories Replacement Parts General Description SAFETY PRECAUTIONS Care and Maintenance CAUTION Detachable Cable WARNING WARNING Wearing the Headset Certifications Flip-Up Mute Function 2/12...
At its sole option, Shure will repair or replace the defective product and promptly return it to you. In order for this warranty to be valid, the consumer must, at the time the product is returned, provide proof of purchase in the form of the original purchase re...
Makasar (0411) 324652 General Description The BRH441M Broadcast Headset and the BRH440M Broadcast Stereo Headset are developed especially for use in broad cast and media production. Circumaural ear cups block out background noise, and the dynamic, cardioid microphone delivers natural, highly intelligible vocal reproduction. Wearable on the left or right side, the flexible boom features a flipup mute func...
Shure Incorporated Detachable Cable Attach the cable by aligning the arrows and pressing firmly into place until locked. Pull on the knurled collar to disengage lock and remove cable. Wearing the Headset Adjust the headband for a comfortable fit. 5/12...
Shure Incorporated Position the boom so the microphone is within 13 mm (1/2 inch) of the corner of your mouth. To avoid "popping" or other breath noise, do not place directly in front of mouth. The boom swivel allows the headset to be worn on either side of your face.
Shure Incorporated Specifications Net Weight without cable BRH440M 376 g (13.26 oz.) BRH441M 240 g (8.5 oz.) Packaged Weight BRH440M 0.8 kg (1.75 lbs) BRH441M 0.69 kg (1.52 lbs) Cable Detachable cable (sold separately) Environmental Conditions Operating Temperature 18° to 60° C (0° to 140° F) Storage Temperature -29°...
Shure Incorporated Polar Pattern Cardioid Frequency Response 50 to 15,000 Hz Output Impedance 150 Ω Sensitivity at 1 kHz, open circuit voltage 66.5 dBV/Pa* (0.47 mV) Polarity Positive pressure on diaphragm produces positive voltage on pin 1 (red wire) with respect to pin 2 (black wire).
Shure Incorporated Accessories Replacement Parts 1 Pair of Replacement Earcup Pads Windscreen Temple Pad 9/12...
Page 10
The following tables describe wiring for BRH detachable cables. All BRH detachable cables contain six conductors with dis crete termination at the Shure 6-pin connector that plugs into the headset. For pre-terminated cables, conductors (and signal) are tied to common contacts at the other end of the cable where shown.
Avoid or damage may occur Certifications This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking. The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance Authorized European representative: Shure Europe GmbH Headquarters Europe, Middle East & Africa Department: EMEA Approval Jakob-Dieffenbacher-Str.