1 Overview
The NoWire Model 1100 provides a wireless link for digital input/output signals.
1. Display readings wirelessly from up to 32 water, gas, and electric meters or run-time sensors via
a wireless connection to your meter's digital pulse output.
2. Display readings from up to 4 direct wired water, gas, and electric meters or run-time sensors
via NoWire's 4 wired pulse inputs.
3. Provide a wireless link for 4 digital output signals to digital input equipment. Any of the 32
wireless or 4 wired input points can be routed to NoWire's 4 optically isolated outputs. This
creates a wireless link for industrial control signals or creating an additional pulse output for
meters.
4. No software is required. All configuration is done through setup menus using the three
pushbuttons and LCD display.
5. Data from NoWire can be pushed to the internet via CellConnect™ GSM Cell modem,
WebConnect™ Ethernet modem, or a third party device via Modbus RTU communications.
2 Warnings
WARNING: A potential risk exists if this Operations and Installation Manual are not followed.
3 NoWire Quick Start
This Quick Start section is to help you get up to speed with how to setup and configure the basics of
NoWire quickly. It is not intended to replace other instructions and details elsewhere in this manual but
to simply allow you to get familiar with the operation of this product.
3.1 Configuring a Wireless Input Pulse Meter
1. You will need the NoWire 1100, a 12VDC power supply, an
EN1501 wireless pulse transmitter, and a small screw driver.
2. Remove the NoWire cover and connect the 12VDC power
supply positive and negative wires to the V+ and V- terminals of
the terminal block in the bottom left corner of the circuit
board.
3. Plug the 12VDC power supply into a 120V outlet and wait for
NoWire to power up and go through its self checks.
4. Follow the steps below. The text between the LCD screen
images is the NoWire button to press to move to the next
screen.
NoWire Model 2100
NoWire Model 2100 Installation and Operation Manual
CHANGE
The setup menus are password protected. The factory default password is 00000 and
may be changed in the System Items sub-menu. Pressing NEXT will get you into the
setup menus.
Submeter Solutions, Inc., 888-64METER
12VDC power supply connection.
NEXT
Page 4
Need help?
Do you have a question about the NoWire 2100 and is the answer not in the manual?