Command Manual – System Maintaining and Debugging
H3C S9500 Series Routing Switches
By default, debugging functions of all modules are disabled.
Note the following:
This command is intended for network administrators to diagnose network failure.
Output of the debugging information may degrade system efficiency, especially
during the execution of the debugging all command. Therefore, use the
command with caution.
After finishing debugging, you can use the undo debugging all command to
disable all the debugging functions.
You must configure the debugging, terminal debugging and terminal monitor
commands first to display detailed debugging information on the terminal. For the
detailed description on the terminal debugging and terminal monitor
commands, refer to Information Center Commands in the System Volume.
Related commands: display debugging.
Examples
# Enable IP packet debugging.
<Sysname> debugging ip packet
1.2.2 display debugging
Syntax
display debugging [ interface interface-type interface-number ] [ module-name ]
View
Any view
Default Level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
module-name: Module name.
Description
Use the display debugging command to display enabled debugging functions.
Related commands: debugging.
Examples
# Display all enabled debugging functions.
<Sysname> display debugging
IP packet debugging is on
Chapter 1 System Maintaining and Debugging
1-8
Commands