Tracert Ipv6 - H3C S9500 Series Command Manual

Command Manual – System Maintaining and Debugging
H3C S9500 Series Routing Switches
6 128.32.197.4
7 131.119.2.5
8 129.140.70.13
9 129.140.71.6
10 129.140.81.7
11 129.140.72.17
12 * * *
13 128.121.54.72
14 * * *
15 * * *
16 * * *
17 * * *
18 18.26.0.115

1.1.4 tracert ipv6

Syntax
tracert ipv6 [ -f first-ttl | -m max-ttl | -p port | -q packet-number | -w timeout ] *
remote-system
View
Any view
Default Level
0: Visit level
Parameters
-f first-ttl: Specifies the first TTL, that is, the allowed number of hops for the first packet,
in the range 1 to 255. It defaults to 1 and must be less than the maximum TTL.
-m max-ttl: Specifies the maximum TTL, that is, the maximum allowed number of hops
for a packet, in the range 1 to 255. It defaults to 30 and must be greater than the first
TTL.
-p port: Specifies the UDP port number of the destination device, in the range 1 to
65535. The default value is 33434. It is unnecessary to modify this parameter.
-q packet-number: Specifies the number of probe packets sent each time, in the range
1 to 65535, defaulting to 3.
-w timeout: Specifies the timeout time of the probe packets, in the range 1 to 65535, in
milliseconds. The default value is 5000 ms.
remote-system: IPv6 address or host name (a string of 1 to 46 characters) of the
destination device.
59 ms 119 ms 39 ms
59 ms 59 ms 39 ms
80 ms 79 ms 99 ms
139 ms 139 ms 159 ms
199 ms 180 ms 300 ms
300 ms 239 ms 239 ms
259 ms 499 ms 279 ms
339 ms 279 ms 279 ms
1-6
Chapter 1 System Maintaining and Debugging
Commands