Toro Sand Pro 5040 Operator's Manual page 8

Figure 12
1. Hydraulic cylinder
2. 90-degree fitting
3. Mount the top of the hydraulic cylinder barrel
to the pin on the right-hand plow plate with a
retaining ring (Figure
Note:
Position the cylinder hydraulic ports
forward.
Figure 13
1. Retaining ring
2. Hydraulic cylinder
3. Pin (on plow plate)
4. Mount the cylinder rod to the push arm straps
with a pin and 2 retaining rings
3. 45-degree fitting
4. Plug (1/8 inch)
13).
4. Push arm strap
5. Pin
(Figure 13).
7
Installing the Hydraulic
Hoses
Parts needed for this procedure:
1 Tube assembly
1 Hydraulic hose (Part No. 108-8449)
1 Hydraulic hose (Part No. 108-8453)
1 Hydraulic hose (Part No. 108-8454)
g003669 1 Wire hose holder
2 Thread forming screw (5/16 x 3/4 inch)
3 Plastic cable tie
Procedure
1. Locate the hydraulic tube that goes from the oil
cooler to the existing lift valve
2. Remove the fasteners and tube clamp securing
the hydraulic tubes to the frame.
3. Disconnect and remove the hydraulic tube from
the oil cooler and the lift valve
Note:
To minimize oil loss when removing
the hydraulic tube, have the replacement hose
ready or cap the fitting on the cooler using one of
the protective shipping caps removed from the
tube assembly, Part No. 108-8447
g028342
1. Oil cooler
4. Secure the remaining hydraulic tube to the
frame with the clamp and fasteners previously
removed
5. Connect the tube assembly, Part No. 108-8447,
to the 90-degree fitting on the left side of the
8
(Figure 14).
(Figure 14).
(Figure
Figure 14
2. Hydraulic tube
15).
g003671