Toro Sand Pro 5040 Operator's Manual page 4

1. Center shroud
3
Installing the Lift Valve
Parts needed for this procedure:
2 Straight hydraulic fitting with O-ring
2
90-degree hydraulic fitting with O-ring
1 Lift valve
1 Valve plate
3 Bolt (1/4 x 3 inches)
3 Locknut (1/4 inch)
2 Bolt (#10 x 1-1/4 inches)
2 Locknut (#10)
1 Lift lever
Procedure
1. Thread the 2 fittings (90-degree) and the 2
straight hydraulic fittings into the new lift valve.
Note:
Position the fittings as shown in
4. Do not tighten the 90-degree fittings at this
time. Make sure that all O-rings are lubricated
and properly positioned on the fittings before
installation.
Figure 3
1. Straight fitting
2. 90-degree fitting
2. Mount the valve assembly, pivot bracket, and
g003662
valve plate to the frame with 3 bolts (1/4 x 3
inches) and 3 locknuts
valve plate against the front of the frame member
when mounting, and torque the fasteners to 10
to 12 N∙m (90 to 110 in-lb).
Note:
the valve currently installed.
3. Loosely mount the pivot lever assembly to the
valve spool and to the offset link with 2 bolts
(#10 x 1-1/4 inch) and 2 locknuts
Note:
Figure
4
Figure 4
3. Lift valve
(Figure
The valve installation is very similar to
Do not tighten the fasteners at this time.
g003663
5). Position the
(Figure 5).