Toro Sand Pro 5040 Operator's Manual page 5

1. Valve assembly
2. Pivot bracket
3. Valve plate
4
Installing the Plow Plates
Parts needed for this procedure:
1 Right plow plate
1 Left plow plate
4 Bolt (1/2 x 2 inches)
4 Locknut (1/2 inch)
1 Hitch frame bracket
2 Bolt (1/2 x 1-3/4 inches)
Procedure
1. Loosely mount the right hand plow plate to the
right side of the caster fork with 2 bolts (1/2 x 2
inches) and locknuts as shown in
Note:
Do not tighten the fasteners yet.
2. Repeat the procedure with the left hand plow
plate (Figure 6).
3. Jack up the front of the machine until the front
wheel is off the floor.
Figure 5
4. Offset link
5. Pivot
6. Lever
Figure
4. Remove and discard the 2 bolts securing the
front of the steering pivot to the top of the caster
fork (Figure
5. Using the caster fork and steering pivot mounting
holes, mount the hitch frame bracket to the
underside of the caster fork with 2 bolts (1/2 x
1-3/4 inches); refer to
Note:
the tire to gain clearance. The wheel motor
hydraulic hose should not rest on top of the hitch
frame bracket.
g003664
1. Right plow plate
2. Left plow plate
6.
5
6).
Figure
It may be required to partially deflate
Figure 6
3. Steering pivot
4. Hitch frame bracket
6.
g003665