Toro Sand Pro 5040 Operator's Manual page 6

5
Installing the Push Arms
and Hitch Frame
Parts needed for this procedure:
1 Hitch frame
2 Bolt (3/8 x 2 inches)
2
Nut (3/8 inch)
2 Capscrew (3/8 x 1-1/2 inches)
2 Locknut (3/8 inch)
2 Cylinder pin
1 Adapter plate
1 Push arm tube
2 Pin assembly
2 Thread-forming screw
2 Bolt (5/8 x 1-1/2 inches)
Washer (1.68-inch outside diameter x 0.65-inch inside
2
diameter)
1 Tube
1 Clevis pin
1 Cotter pin
Procedure
1. Lower the machine so that the front wheel is on
the floor.
2. Secure the push arm tube to the adapter
plate with 2 pin assemblies and secure the
pin assemblies to the adapter plates with 2
thread-forming screws.
Note:
Position the components as shown in
Figure 7.
1. Push arm tube
2. Adapter plate
Figure 7
3. Pin assembly
4. Thread-forming screw
3. Insert a cylinder pin into each push arm tube as
shown in
4. Insert the push arm tubes onto the right and left
plow plates aligning the cylinder pin guides with
the holes in the plow plates
Note:
If unable to get the push arm tubes
around the plow plates, loosen the nuts securing
the plow plates to the caster fork.
5. Mount each cylinder pin to each plow plate
with a bolt (5/8 x 1-1/2 inches) and a washer
(1.68-inch outside diameter x 0.65-inch inside
diameter) as shown in
Note:
Torque the bolts to 203 N-m (150 ft-lb).
1. Cylinder pin
6. Mount the top of the hitch frame to the hitch
frame bracket with 2 bolts (3/8 x 2 inches) and
nuts (Figure
7. Mount the hitch frame tubes to the plow plates
with bolts (3/8 x 1-1/2 inches) and nuts
9), and tighten the fasteners.
g003787
6
Figure 8.
(Figure
Figure 8.
Figure 8
2. Push arm tube
9).
8).
g003666
(Figure