Packet Control; Diseqc Search; Motor; Spectrum - Openbox TSC-200 HEVC User Manual

If you don't know the signal information of some usual sat, in this menu,please wait a moment, it will find the satellite
identify.

4.2.3 Packet Control

Main Menu-> Satellite -> Packet Control
In this menu, you can know the strength and quality of each transponder under the satellite.
Note: The satellite showed in this menu is what you selected in the menu of select satellite.

4.2.4 DiSEqC Search

Main Menu-> Satellite ->DiSEqC Search
If you connect to the DiSEqC 1.0 or DiSEqC1.1, it will search the satellite which it is connected, then you can press F1
button to the port which you searched .You also can press the F2 button to change DiSEqCtype, pressF4 button to
change LNB Type,

4.2.5 Motor

Main Menu-> Satellite ->Motor
Highlight the Motor and press ok button to enter the motor search. In this menu, you also can execute Delete, Add, and
Move to and Renamesatelliteand Delete, Add, Delete, and Edittransponder and Edit PID.

4.2.6 Spectrum

Main Menu-> Satellite ->Spectrum
In this menu, you can know the strength of all transponders.
Note: After insert USB, you can press OK button to save or load the data of spectrum. If you select saving the data, you can
press OK button or exit button to close the save. Thenyou can find "spectrum_file_001.txt "in your USB. If you select
-Select TP:Highlight the transponder and press F1
button to enter TP list, and select what you want,
thenhighlighted transponder will become you
selected, and display the
-Satellite Search: PressF2 button to search all
transponders of this satellite.
-Change DiSEqC: Press F3 button to change
DiSEqC Port.
-LNB Type:Press F4 button to change LNB Type.
-West/East: Press F1 button to turn Motor to west and
press F2 button to turn Motor to east.
-Start Search:After configure the antenna setting, press
the F3 button to TP search.
-Setup:If you set the motor mode to USALS, you need
press F4 button to set the longitude and latitude.
-Motor mode: Highlight the Motor and press the ◄/►
button to select DiSEqC1.2 or USALS.
Note: After enter setup menu, you should turn your
machine until it is show the compass.
7
strength and quality.