Table of Contents
Advertisement
4.3.1 TP Search
Main Menu->Terrestrial ->TP Search
In this menu, you can Delete, Add, Search Channels.
-Search Channel:Pressthe ◄/► button to change search type, you can select manual search, auto search.
-Delete: Highlight the TP and select the TP,then press F1 button to delete TP
-Add: PressF2 button to add TP.
-Manual Search:Press F1 button to search channels from the selected TP.You will be asked to confirm whether only search
FTA channels or not, if you select "Yes", you will only search FTA channels. You also will be asked to confirm whether network
search or not, if you select "Yes", it will go to search automatically and save the found channels when the search is
completed.
-Auto Search: PressF4 button to search channels of all TP.You will be asked to confirm whether Network Search or not, if
you select "Yes", it will go to search automatically and save the found channels when the search is completed.
4.3.2 TP IDE.
Main Menu->Terrestrial ->TP IDE.
In this menu, you can know the exact information about the transponder which you selected. You also can execute Delete
and Add transponder, Manual Search and Auto Search.
4.3.3 Packet Control
Main Menu->Terrestrial ->Packet Control
In this menu, you can know the strength and quality of each transponder.
-TP:Highlight the TP, press the ◄/► button to switch
TP or press the ok button to enter TP list, then select
TP.In the TP list, you can press the ◄/► button to
switch TP one by one, and press ▲/▼ button to Page
up/down TP list. You also can enter channel number to
select TP.
-Band: Pressthe ◄/► button to change band to
6M/7M/8M.
-MER:Modulation error rate.
-SNR: It will show the carrier to noise ratio of the
transponder which you selected.
-CBER:Forward error correction.
-VBER:Afterward error correction.
-Power: It will show you the strength of the transponder
what you selected.
-Modulate:Modulation efficiency.
-FFT Mode:Fast Fourier Transform
9
Advertisement
Table of Contents
