Switching The Laser Beams On; Switching The Laser Beams Off; Setting The Laser Beam For The "Inclined Line" Function; Examples Of Applications - Hilti PM 30-MG Operating Instructions Manual

5.5

Switching the laser beams on

1. Set the selector switch to the
➥ The vertical laser lines are switched on.
2. Press the line mode button repeatedly until the desired line mode is set.
➥ The operating modes change in the following sequence and the sequence repeats itself: vertical lines,
vertical side line, horizontal line, vertical and horizontal lines.
5.6

Switching the laser beams off

1. Set the selector switch to the OFF position.
➥ The laser beam is switched off and the pendulum is locked.
CAUTION
Risk of injury by unintended starting!
▶ Before inserting the battery, make sure that the product is switched off.
2. The laser beam is switched off automatically when the battery is low.
5.7

Setting the laser beam for the "Inclined line" function

1. Set the selector switch to the
2. Press the line mode button repeatedly until the desired line mode is set. → page 7
When the "Inclined line" function is active, the pendulum is locked and the laser is not leveled.
The laser beam(s) blink every 5 seconds.
5.8

Examples of applications

5.8.1 Transferring heights
Printed: 08.05.2019 | Doc-Nr: PUB / 5492798 / 000 / 00
position (ON / unlocked).
position (ON / locked).
English 7