Configuring An Aggregation Group Name; Configuring A Service Loop Group - H3C S3610 Series Operation Manual

Operation Manual – Link Aggregation
H3C S3610&S5510 Series Ethernet Switches
For a static LACP aggregation group containing only one port, the only way to
remove the port from the aggregation group is to remove the aggregation group.
Note:
When making configuration, be aware that after a load-balancing aggregation group
changes to a non-load balancing group due to resources exhaustion, either of the
following may happen:
Forwarding anomaly resulted from inconsistency of the two ends in the number of
selected ports.
Some protocols such as GVRP malfunction because the state of the remote port
connected to the master port is unselected.

2.1.3 Configuring an Aggregation Group Name

Follow these steps to configure a name for an aggregation group:
Enter system view
Configure a name for a
link aggregation group

2.1.4 Configuring a Service Loop Group

Follow these steps to configure a service loop group:
Enter system view
Create a manual
aggregation group
Specify the aggregation
group as a service loop
group that is of specific
type
Enter Ethernet port view
Add the Ethernet port to
the aggregation group
To do...
system-view
link-aggregation group
agg-id description
agg-name
To do...
system-view
link-aggregation group agg-id
mode manual
link-aggregation group agg-id
service-type tunnel
interface interface-type
interface-number
port link-aggregation group
agg-id
Chapter 2 Link Aggregation Configuration
Use the command...
Use the command...
2-3
Remarks
––
Required
None is configured by
default.
Remarks
––
Required
Required
––
Required