H3C S3610 Series Operation Manual page 3

Operation Manual – Link Aggregation
H3C S3610&S5510 Series Ethernet Switches
Table 1-1 Consistency considerations for ports in an aggregation
Category
STP
QoS
GVRP
Q-in-Q
BPDU tunnel
VLAN
Port attribute
State of port-level STP (enabled or disabled)
Attribute of the link (point-to-point or otherwise) connected to the
port
Port path cost
STP priority
Maximum transmission rate
Loop protection
Root protection
Port type (whether the port is an edge port)
Traffic policing
Traffic shaping
Congestion avoidance
Port rate limiting
Strict priority (SP) queuing
Weighted round robin (WRR) queuing
Weighted fair queuing (WFQ)
Port priority
Port trust mode
GVRP state on ports (enabled or disabled)
GVRP registration type
GARP timers
State of Q-in-Q (enabled or disabled)
Added outer VLAN tag
Policy of appending outer VLAN tag according to inner VLAN IDs
BPDU tunnel state on ports (enabled or disabled)
BPDU tunnel state for STP on ports (enabled or disabled)
VLANs carried on the port
Default VLAN ID on the port
Link type of the port, which can be trunk, hybrid, or access
sub-net VLAN configuration
protocol VLAN configuration
VLAN tag configuration
Port rate
Duplex mode
Up/down state of the link
Isolation group membership of the port
1-2
Chapter 1 Link Aggregation Overview
Considerations