Table of Contents
Advertisement
INSTALLING THE HARD DISK POWER BOOST MODULE
(cont.)
Procedure:
Installing the Hard Disk Power Boost Module
----------
/
3.
Remove excess grease with a paper towel.
4.
Remove the seven-wire power boost module cable from the
shipping kit, and plug the end with the nine pin female
connector onto the male connector of the power boost module.
These connectors are keyed to facilitate proper orientation.
5.
Dress the seven wires of the power boost module cable under
the central metal partition of the HORIZON.
6.
If you do not have male terminals attached to your filter
capacitors, remove the screw attaching the thick red wires
to the top of the largest capacitor.
Save the lockwasher.
---->
14
HORIZON Hard Disk Installation Guide
Advertisement
Table of Contents
