2 Warnings / Disclaimers All device operational procedures must be learned on the ground. uAvionix is not liable for damages arising from the use or misuse of this product. This equipment is classified by the United States Department of Commerce's Bureau of Industry and Security (BIS) as Export Control Classification Number (ECCN) 7A994.
For the duration of the warranty period, uAvionix, at its sole option, will repair or replace any product which fails in normal use. Such repairs or replacement will be made at no charge to the customer for parts or labor, provided that the customer shall be responsible for any transportation cost.
11 Return to Service Procedure .............. 18 11.1 Maintenance Records ..............18 12 Support ....................18 Appendix A – Installation Record .............. 19 UAV-1002513-001 Rev A...
When this document is revised, every page will be revised to indicate current revision level. Owner/operators may obtain the latest revision of this document at www.uavionix.com or by contacting a uAvionix dealer. They may also register for updates and support at www.uavionix.com. UAV-1002513-001 Rev A...
5.3 Acronyms and Abbreviations The following acronyms may be used in this document: ADS-B Automatic Dependent Surveillance Broadcast Approved Model List Air Traffic Control Code of Federal Regulations Federal Communications Commission Federal Aviation Administration Global Positioning System Instructions for Continued Airworthiness ICAO International Civil Aviation Organization Instrument Flight Rules...
• LED status light that provides indication of proper operation This device transmits ownship Automatic Dependent Surveillance- Broadcast (ADS-B) data through the UAT data link. tailBeacon replaces an existing rear (white) position light. It must be installed as shown in the tailBeacon STC Installation Manual. UAV-1002513-001 Rev A...
6.2 Interfaces Aircraft Power (14/28V) Transponder Position Light Wi-Fi Breaker iOS/ Android Device BLACK Aircraft Ground 7 Control and Operation During normal operation, the pilot has no direct interface or control of the tailBeacon except for activating using the Position Light switch. Primary user interface controls are provided by the aircraft’s existing transponder, including selection of Mode A squawk code and IDENT.
• Ground power source (capable of supplying sufficient power to the aircraft systems and avionics) • iOS or Android Mobile Device with “uAvionix skyBeacon Installer” • Dark glasses for viewing LEDs directly at close range • Optional or as required: Transponder ramp test set (e.g. Sun UAT1)
8.3 Maintenance Intervals Periodic checks of the tailBeacon system installed by the STC referenced in Section 5 are specified in Table 8-1 at specific intervals. Table 8-1 Maintenance Intervals Item Description/Procedure Section No. Interval Equipment Removal and On Condition Removal and installation of the tailBeacon Replacement...
Ensure a recent “Last Altitude 12 Calendar Calibration” Date encoder tailBeacon Months testing, for TSO User operations Installation Guide Section 10.4 Altitude Altitude encoder tested In accordance encoder and found to comply with 14 CFR testing, for with Part 43 Appendix E Part 91.411 Section (c) and Part 43...
8.4.2 Position Light Visual Inspection The rear position light is designed with 2 white LEDs. If any one LED fails, the unit must be repaired or replaced. Note: Use dark glasses or cover the device to ensure eye safety during LED inspection.
• Ensure transponder is turned OFF • Set the primary flight altimeter to 29.92 inches of mercury • Turn on the tailBeacon • Open the “uAvionix skyBeacon Installer” as detailed in tailBeacon TSO User and Installation Guide Section 10 • Connect to tailBeacon •...
Page 17
• Allow GPS up to 15 blinking On/Off and no position shown in app minutes to obtain position • Internal fault or other • Contact uAvionix Other fault - Annunciator LED configuration issue blinking or constant On and other error indicated in app •...
• Any other applicable information related to the maintenance work performed on the aircraft. Appendix A includes an installation record that should be completed and updated as appropriate with every maintenance action. 12 Support For additional questions or support please visit: http://www.uavionix.com/support/ UAV-1002513-001 Rev A...
Appendix A – Installation Record A copy of this appendix must be used to record installation information and must be kept in the aircraft permanent records. NOTE: A copy of this form must be sent to maintenance@uavionix.com. tailBeacon Installation and Configuration Log Date:...