Table of Contents
Advertisement
Saving a new inflation pressure in
the monitoring system*
In order for the tire pressure monitoring sys-
9
tem
to function correctly, tire pressure refer-
ence values must be saved correctly. To help
ensure that the system can correctly alert the
driver of low inflation pressure, this must be
done each time the tires are changed or the
inflation pressure is adjusted.
For example, when driving with a heavy load
or at high speeds (over 160 km/h (100 mph)),
tire pressure should be adjusted to the Volvo-
recommended tire pressure values. The sys-
tem should then be reset by saving the new
inflation pressure.
To store the new inflation pressure as a refer-
ence value in the system:
1.
Switch off the ignition.
2. Inflate the tire to the correct inflation pres-
sure; see the tire pressure placard on the
driver's side B pillar for recommended
pressures for factory-mounted tires.
3. Start the vehicle.
4. Open the
Car Status
app in App view.
5. Tap
TPMS
.
9
Tire Pressure Monitoring System (TPMS)
NOTE
The vehicle must be stationary for the
Store Pressure
button to be selectable.
6. Tap
Store Pressure
.
7. Tap
OK
to confirm that the tire pressure in
all four tires has been checked and
adjusted.
8. Drive the vehicle until the new inflation
pressure has been saved. The new infla-
tion pressure is stored when the vehicle is
driven at speeds over 35 km/h (22 mph).
> When enough data has been collected
for the system to detect low inflation
pressure, the animation showing the
progress of the storing procedure will
disappear from the center display. The
system will not provide any further con-
firmation that the new inflation pres-
sure has been stored.
If storing cannot be performed,
pressure unsuccessful. Try again.
displayed.
If the vehicle's ignition is switched off before
the new inflation pressure has been saved, the
procedure must be performed again. To help
ensure that the new inflation pressure is saved
correctly, allow the storing procedure to com-
plete during a single operating cycle.
WARNING
The exhaust gases contain carbon monox-
ide, which is invisible and odorless but very
poisonous. The procedure for saving a new
inflation pressure must therefore always be
performed outdoors or in a workshop with
exhaust gas extraction.
Related information
Recommended tire pressure (p. 547)
•
Adjusting tire pressure (p. 546)
•
Viewing tire pressure status in the center
•
display* (p. 550)
Action when warned of low tire pressure
•
(p. 551)
Tire pressure monitoring system* (p. 547)
•
Storing
will be
WHEELS AND TIRES
549
* Option/accessory.
Advertisement
Table of Contents
