Table of Contents
Advertisement
4. Locate the "training" button
receiver for the e.g. garage door opener. It
is usually located near the antenna bracket
on the receiver.
5. Press and release the "training" button
once. Programming must be completed
within 30 seconds after pressing the but-
ton.
6. Press and release the HomeLink
to be programmed. Repeat the press/
hold/release sequence a second time. For
some receivers, the sequence may need to
be repeated a third time.
> Programming is now completed and
the garage door, gate, etc. should now
be activated when the programmed
button is pressed.
If you experience any difficulties programming,
®
please contact HomeLink
at:
21
The name and color of the button varies depending on the manufacturer.
www.HomeLink.com, or call
1–800–355–3515.
Programming individual buttons
To program an individual HomeLink
1.
Press and hold the desired button for
about 20 seconds.
2. When the indicator light on HomeLink
starts flashing slowly, it is possible to pro-
21
gram as usual.
on the
Note: If the button you are reprogram-
ming does not program with a new
device, it will return to the previously
saved programming.
Resetting the HomeLink
It is only possible to reset all HomeLink
tons at once. It is not possible to reset individ-
®
button
ual buttons. Individual buttons can only be
reprogrammed.
Press and hold the outer buttons (1 and 3)
–
on HomeLink
> When the indicator light goes from a
steady glow to flashing, the buttons
have been reset and are ready for
reprogramming.
®
button:
®
®
buttons
®
but-
®
for about 10 seconds.
STARTING AND DRIVING
Related information
®
•
Using HomeLink
* (p. 466)
®
•
HomeLink
* (p. 463)
•
Type approval for HomeLink
* Option/accessory.
®
* (p. 466)
465
Advertisement
Table of Contents
