EGO Power+ LM1700E Operator's Manual page 17

PROBLEM
The mower does not
mulch properly
There is excessive
vibration
The handle locking
clamps cannot be
closed in position.
CAUSE
◾
Wet grass clippings are sticking to the
underside of the deck.
◾
The mower is set to cut too much grass at
once.
◾
The cutting blade is loose.
◾
The cutting blade is unbalanced.
◾
The cutting blade is bent.
◾
The motor shaft is bent.
◾
The side rails are not fully extended.
56 VOLT LITHIUM-ION CORDLESS MOWER — LM1700E
SOLUTION
◾
Wait until the grass dries before
mowing.
◾
Raise the deck to a higher cutting
height setting.
◾
Tighten the blade bolt.
◾
Balance the blade following the
instructions.
◾
Replace the blade.
◾
Contact the service center.
◾
Fully extend the side rails, then lock
the clamps.
17