Matrox Rapixo CXP Installation And Hardware Reference page 28

28 Chapter 2: Hardware installation
Matrox R apixo- CXP
detected a non-PoCXP
compliant connection
Power is not provided.
The length of cable that you choose will affect the maximum data transmission
rate. In general, for lengths greater than 40 m, the longer your cables, the lower
the maximum possible bit rate. For example, when using high-quality, 100 m
cables, the maximum possible bit rate is 3.125 Gbits/sec. Another factor that
affects the bit rate is the quality of the cables that you choose.
CoaXPress LEDs
The four CoaXPress LEDs on the main bracket identify the state and activity of
connected devices. The LEDs respect the JIIA CoaXPress Standard version 2.0
specification for connector indicator lamps. The typical sequence of LED states
is as follows:
Non-PoCXP
compliant device
has
Orange, fast flash
.
Orange, solid Matrox R
Red, slow pulse Matrox R
but nothing is connected.
PoCXP-compliant
device
Alternating green/orange,
fast flash
Matrox R
connection with the device. Note that this
Green, Solid
requires an MdigAlloc() call. No data is
being transferred.
Matrox R
trigger. Note that this state only occurs in
Orange, slow pulse
triggered grab mode.
Data is being transferred.
Green, fast flash
apixo- CXP is booting.
apixo- CXP driver has started,
Matrox R apixo- CXP
detected a PoCXP-
compliant connection
Power is provided.
apixo- CXP has establish ed
apixo- CXP is waiting for a grab
has
.
a