CEBEK TL-63 Manual

CEBEK TL-63 Manual

2 channels biestable receiver via cable

Advertisement

Quick Links

The TL-63will decode codes sent from the emitter, recognizing channels and connecting or disconnecting consequently
outputs. It admits TL-50 and TL-51 transmitters .
It includes micro switches to select the code, indicator leds, and connection terminals.

INSTALLATION

Note. Before to start the installation, it is very important to carefully read the TL-55's (booster) instruction manual, then you
could use this module.
POWER SUPPLY AND DATA ENTRY. The TL-63 supply doesn't require an external power supply. The module will be fed
directly from the Receivers Communication Cable, provided by the booster, which also supply control data. For this
connection do not use an independent cable from each receiver to the booster, but an union cable between your TL-61 and
the Mmin Communication cable with Receivers. See Fig 1.
Therefore, connect the positive and the negative cables of the power supply input and Data of the TL-61 to the respective positive and
negative Communication Cable with Receivers. Before to follow the installation, make sure that the assembly has been correctly done.
2 CHANNELS BIESTABLE
RECEIVER VIA CABLE

TECHNICAL CHARACTERISTICS

Voltage. ........................................................................... Through the booster.
Minimum Consumption. ................................................... 20 mA.
Maximum Consumption. .................................................. 120 mA.
Max Load per Output . ...................................................... 3 A.
Protection against polarity inversion, (P.I.P.). ................... Yes.
Dimensions. .......................................................................106 X 62 X 30 mm.
.
www.cebek.com
-
sat@cebek.com
TL-63

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TL-63 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for CEBEK TL-63

  • Page 1 POWER SUPPLY AND DATA ENTRY. The TL-63 supply doesn’t require an external power supply. The module will be fed directly from the Receivers Communication Cable, provided by the booster, which also supply control data. For this connection do not use an independent cable from each receiver to the booster, but an union cable between your TL-61 and the Mmin Communication cable with Receivers.
  • Page 2 TL-61 OUTPUT CONNECTION. LOAD. The TL-63 outputs are controlled by a relay, and accepts any device up to 3 A. The relay is not a component supplying voltage but its function is limited to accept or deny the voltage passage like a standard switch.
  • Page 3 3). Like in the DP1 battery, switches not used, in this case the 3 and 8, must to remain to 0 (In OFF position). OPERATING WITH L-50 TRANSMITTER. If in you Via Cable Cebek system you have installed as transmitter the TL-50,...
  • Page 4 8. Finally, see fig 6 where you can find the final result. OPERATING MODE. Once the installation done, and configured the TL-63 with its identification codes for each channel, the module will be awaiting order from station.

Table of Contents