Table of Contents
Advertisement
NI-VXI Software Installation and Configuration
Run
nivxi.INSTALL
Enter the following command:
./nivxi.INSTALL
You will receive the following prompt:
Should the driver be loaded during each reboot? [y/n] (y):
The default is
for yes. If you do not want the driver to be automatically loaded during a restart,
y
type
and then <Enter>. If you later decide to have the driver load automatically during the
n
boot sequence, or if you have removed the driver from the boot sequence and you now wish to
return it, then simply rerun the
If the driver is installed correctly, the following message appears:
nivxi: module loaded; id= #
where
is an identification number that is returned by the operating system.
#
The following message appears on the console:
NI-VXI device driver loaded.
Copyright (c) 1994 National Instruments Corporation
All Rights Reserved.
If the driver is already loaded, the following message appears on the console:
Can't load this module:
Note:
If you want to load the driver for this session only, use the following script instead of
the
INSTALL
/dev/nivxi.LOAD
Unloading the NI-VXI Driver for Solaris 1.x
To unload the driver, you must meet the following requirements:
•
You must have super-user privilege.
•
The driver must not be in use.
If the driver is in use and you try to unload it, the following message appears:
Cannot unload the module:
VXI-SB2020 and NI-VXI for Solaris
in your working directory and follow the instructions in the shell script.
nivxi.INSTALL
No such device or address.
script:
Device busy.
script.
3-4
© National Instruments Corporation
Chapter 3
Advertisement
Table of Contents
