Figure 2-1. Sb-Mxi Installed In A Sparcstation 1+ - National Instruments VXI-SB2020 Getting Started

Chapter 2 Hardware Configuration and Installation
6. Align the SBus connector plug of the SB-MXI with the SBus socket and gently press the
plug into the socket.
7. Check the installation.
8. Replace the cover to the system unit.
Figure 2-1 illustrates the installation of an SB-MXI into a SPARCstation 1+.
SB-MXI Board
SBus Connector
MXI Connector
SBus
Cutouts

Figure 2-1. SB-MXI Installed in a SPARCstation 1+

© National Instruments Corporation 2-3 VXI-SB2020 and NI-VXI for Solaris