Connection Of Machine Head Electric Equipment To Drive - DURKOPP ADLER 887 Series Operating Instructions Manual

5.4

Connection of machine head electric equipment to drive

A. The machine is equipped with the DAC basic/classic drive
M
SYNC
4
1
–
Connect the sewing head connection cable into the connector (1)
signed with the machine symbol.
–
Connect the control panel into the connector (2) signed with the
panel symbol.
–
Connect the motor encoder connector into the connector (E).
–
Connect the motor connector into the connector (M).
–
Connect the pedal position sensor into the connector (3) signed
with the pedal symbol.
–
Connect "machine identification" into the connector ID.
–
Connect the proximity switch to the connector (SYNC) if the sewing
machine has a gear ratio different from 1:1.
–
The connector (4) is used for the connection of other peripheries,
e. g. a knee lever or an electric hand wheel.
E
2
EN
3
ID
19