Machine Automatic Function - DURKOPP ADLER 887 Series Operating Instructions Manual

8. Sewing with machine with positioning motor
8.1 Machine automatic functions
Automatic function
Needle positioning
Bartacks
Initial bartack
End bartack
Thread trimming
Automatic foot lifting
* The seam is finished after the pedal shifting to the position -2 (if the thread trimming is pre-selected, then after
the trimming).
** The decorative bartack is characterized by the fact that the needle sews stitch in stitch in the previous seam at
the bartacking. At the sewing direction change the machine stops for a moment.
36
The machine has the below functions which are automatically
performed during the seam sewing depending on:
–
Pre-selection
–
Pedal position (according to the machine operator´ s selection)
–
Working phase of seam sewing
Pre-selection
Needle down at machine stopping in seam
•
Needle up at machine stopping in seam
•
Note: after the seam * finishing the machine stops always
with the needle up.
• Standard
Decorative**
•
Single
•
• Double
Standard bartack stitch number forwards
•
• Decorative bartack stitch number forwards
Standard bartack stitch number backwards
•
• Decorative bartack stitch number backwards
• Single
Double
•
Standard bartack stitch number backwards
•
Decorative bartack stitch number backwards
•
Standard bartack stitch number forwards
•
Decorative bartack stitch number forwards
•
ON
•
OFF
•
Foot lowered at stopping in seam
•
Foot lifted at stopping in seam
•