Sony SLV-EZ727AZ, SLV-EZ725AZ, SLV-EZ424AZ, SLV-EZ121AZ Operating Instructions Manual page 17

To cancel the Auto Set Up function
Press MENU.
To change the RF channel
If the picture does not appear clearly on the TV, change the RF channel on
the VCR and TV. Select INSTALLATION from the menu, then press M/m
to highlight VCR OUTPUT CH and press ,. Select the RF channel by
pressing the M/m buttons. Then, tune the TV to the new RF channel so that
a clear picture appears.
Notes
• Whenever you operate the Auto Set Up function, some of the settings (timer, etc.)
will be reset. If this happens, you have to set them again.
• Auto preset starts automatically only when you plug in the mains lead for the first
time after you purchase the VCR.
• Auto preset can be performed by pressing x STOP on the VCR continuously for
5 seconds or more with no tape inserted.
Getting Started 17