Advertisement
Maintenance and Servicing instructions
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
Make sure that the trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
tO prEVEnt SEriOuS inJury FrOM tOOL FaiLurE:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
Blade Maintenance
1. Unplug the tool.
2. Using the Hex Tool, remove the three Head Bolts.
3. The three Blades and the two Bushings will be loose.
4. Clean, replace or sharpen the blades as
required. Replace blades as a set only.
Right
Blade
Center
Blade
Bushing
Left Blade
cleaning, Maintenance, and Lubrication
1. BEFOrE EacH uSE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
Page 8
Cutting
Head
Head
Bolts
For technical questions, please call 1-888-866-5797.
5. Reassemble by repositioning the Blades,
and Bushings as illustrated. Replace the
Head Bolts and tighten them securely.
6. Test the product to be sure that it is working properly.
7. The Left and Right Blades are slotted.
They can be adjusted to change the direction
of the curl of waste material. To adjust:
a. Unplug the tool.
b. Loosen all three Head Bolts.
c. Make a slight adjustment to the Left
or Right Blade as needed.
d. Tighten the Head Bolts.
e. Test the direction of the waste curl and
repeat the steps above as needed.
note: If the Head Bolts are overtightened,
then the Center Blade will not move freely
enough, causing premature wear, or possibly
preventing the tool from operating.
If the Head Bolts are not tight enough, the tool
will not make a smooth cut in the material
2. aFtEr uSE, wipe external surfaces
of the tool with clean cloth.
3. Use dry, compressed air to clean out
the vents on the motor housing.
nOticE: Do not use cleaning agents to clean the softer
parts of the tool. Use only a mild detergent or a damp
cloth. Do not let water come into contact with tool.
4.
WarninG! if the plug or the supply cord
of this power tool is damaged, it must be
replaced only by a qualified service technician.
Item 62213
Advertisement
