C2. Check Parking Brake Lever Stroke And Play - Mitsubishi Pajero Sport 2013 Inspection And Maintenance Manual

2-44
CLUTCH PEDAL CHECK AND
ADJUSTMENT
1. Turn back the carpet etc. under the clutch pedal.
Clutch pedal height
A
2. Measure the clutch pedal height. If the height is
outside the standard value, go to step 4.
Standard value (A):
<LHD> 183.5 − 186.5 mm
<RHD> 178.5 − 181.5 mm
3. Measure the clutch pedal clevis pin play. If the
play is outside the standard value, go to Step 5.
Standard value (B): 1 − 3 mm
4. Remove the clutch switch. <Vehicles with cruise
control>
CAUTION
Do not push in the master cylinder pushrod at
this time, otherwise the clutch will not operate
properly.
Pushrod
Setting nut
13 ± 2 N·m
5. If the clutch pedal height is not within the standard
value, loosen the setting nut and the locking nut
<Vehicles without auto-cruise control> to adjust
the clutch pedal height to the standard value and
move the pushrod and the adjusting bolt
<Vehicles without auto-cruise control>.
6. Install the clutch switch. <Vehicles with cruise
control>
7. If the clutch pedal clevis pin play is not within the
standard value, loosen the setting nut and move
the pushrod to adjust.
PERIODIC INSPECTION AND MAINTENANCE
OPERATIONS INSIDE THE VEHICLE
Clutch pedal clevis pin play
B
AC001133 AD
Adjusting bolt
Locking nut
Clutch pedal
AC712192 AC
Clutch pedal free play
Distance between the clutch pedal
and the floorboard when the clutch
is disengaged
D
8. After the adjustments, confirm that the clutch
pedal free play (measured at the face of the pedal
pad) and the distance between the clutch pedal
(the face of the pedal pad) and the floorboard
when the clutch is disengaged are within the
standard value ranges.
Standard value (C): 4 − 13 mm
Standard value (D):
<LHD> 74 mm or more
<RHD> 76 mm or more
9. If the measured free play and distance do not
agree with the standard value ranges, it is
probably the result of either air in the hydraulic
system or a faulty master cylinder or clutch. Bleed
the air, or disassemble and inspect the master
cylinder or clutch.
10.Reinstall the carpet, etc.
C2. CHECK PARKING BRAKE LEVER
STROKE AND PLAY
Pull the parking brake lever with a force of approxi-
mately 200 N and count the number of notches.
Standard value: 8 − 9 notches
<Vehicles with rear drum brake>
If the parking brake lever stroke is not the standard
value, adjust as described below.
1. Remove the floor console panel.
C
AC001135AB
M6020400200744