A11. Check Air Cleaner Element For Clogging And Damage - Mitsubishi Pajero Sport 2013 Inspection And Maintenance Manual

2-30
<6B31-Left bank>
Power steering
oil pump
<6B31-Right bank>
140 ± 5 N·m
9. Install the cylinder block drain plug and new
gasket, and then tighten the cylinder block drain
plug to the specified torque.
Tightening torque:
<Left bank> 29 ± 5 N⋅m
<Right bank> 140 ± 5 N⋅m
10.Securely tighten the drain plug of the radiator.
11.Reinstall the radiator condenser tank.
CAUTION
Do not use alcohol or methanol anti-freeze or any
engine coolants mixed with alcohol or methanol
anti-freeze. The use of an improper anti-freeze
can cause corrosion of the aluminium compo-
nents.
12.By referring to the section on coolant, select an
appropriate concentration for safe operating
temperature within the range of 30 to 60%. Use
special tool LLC changer (MB991871) to refill the
coolant. A convenient mixture is a 50% water and
50% antifreeze solution (freezing point: −31°C).
PERIODIC INSPECTION AND MAINTENANCE
OPERATIONS INSIDE THE ENGINE COMPARTMENT
29 ± 5 N·m
AC903246 AC
Alternator
AC903247 AC
MB991871
AC503144 AB
Recommended antifreeze: MITSUBISHI
MOTORS GENUINE SUPER LONG LIFE
COOLANT or equivalent
Quantity (includes 0.65 L in the radiator con-
denser tank):
<4M41> 8.5 L
<4D56> 8.2 L
<6G74> 8.8 L
<6B31> 11.0 L
<4G64> 7.5 L
NOTE: For how to use special tool, refer to its
manufacturer's instructions.
13.Remove the special tool, and then reinstall the
radiator cap.
14.Start the engine and let it warm up until the
thermostat opens.
15.After repeatedly revving the engine up to 3,000
r/min several times, then stop the engine.
16.Remove the radiator cap after the engine has
become cold, and pour in coolant up to the brim.
Reinstall the radiator cap.
CAUTION
Do not overfill the radiator condenser tank.
17.Add coolant to the radiator condenser tank
between the "FULL" and "LOW" mark if
necessary.
A11. CHECK AIR CLEANER ELEMENT
FOR CLOGGING AND DAMAGE
1. Check air cleaner element for clogging and
damage.
2. Clean deposited dust from the element in the
following manner.
(1) Lightly tap the element against the top of a
bench.
(2) Blow compressed air from inside the element.
3. Wipe off dust on the air cleaner interior.
4. Install the air cleaner body.
M6020201200851
AC502427