Processor Adjustment Range - Sony 3-869-574-12(1) Operating Instructions Manual

S-video (DSR-1600A):
30 Hz to 5.0 MHz ±1.0 dB (Y),
5.75 MHz +0/−3.0 dB (Y) (TM)
S-video (DSR-1600AP):
25 Hz to 5.0 MHz ±1.0 dB (Y),
5.5 MHz +1.0/−2.0 dB (Y),
5.75 MHz +0/−3.0 dB (Y) (TM)
Component (DSR-1600A):
30 Hz to 5.0 MHz ±1.0 dB (Y),
5.75 MHz +0/−3.0 dB (Y) (TM),
30 Hz to 1.3 MHz ±1.0 dB (C),
1.5 MHz +0/−5.0 dB (C)
Component (DSR-1600AP):
25 Hz to 5.0 MHz ±1.0 dB (Y),
5.5 MHz +1.0/−2.0 dB (Y),
5.75 MHz +1.0/−3.0 dB (Y) (TM),
25 Hz to 1.5 MHz ±1.0 dB (C),
2.0 MHz +1.0/−2.0 dB (C)
S/N Composite output (Y):
53 dB or more
S-video output (Y): 55 dB or more
Component output (Y): 55 dB or more
Y/C delay 30 ns or less
K-factor 2.0% or less (K2T, KPB)

Processor adjustment range

Video level ±3 dB/−∞ to 3 dB selectable
Chrome level ±3 dB/−∞ to 3 dB selectable
Setup/Black level
±30 IRE (±210 mV)
Chroma phase ±30°
Y/C delay ±100 ns
Sync: ±1 μs
System phase
SC: ±180°
* +2 μs to –3 μs when using a TBC remote control unit
Audio performance
Frequency response
Two-channel (48 kHz) mode:
20 Hz to 20 kHz +0.5 dB/−1.0 dB
Four-channel (32 kHz) mode:
20 Hz to 14.5 kHz +0.5 dB/−1.0 dB
Dynamic range More than 90 dB
Distortion (THD + N)
Less than 0.05% (48 kHz)
*
Input connectors
Analog video inputs
REF. VIDEO IN
BNC type (×2, loop-through)
Black burst
0.286 Vp-p (DSR-1600A) or 0.3 Vp-p
(DSR-1600AP), 75 Ω, negative sync
Composite sync
Output connectors
Digital signal outputs
SDI OUT (with optional DSBK-1601 SDI/AES/EBU
Output Board installed)
BNC type (×2, active-through), Serial
Digital Interface format (270 Mbps),
SMPTE 259M/ITU-R BT.656
DV IN/OUT 6-pin IEEE 1394 connector
Analog video outputs
REF. VIDEO OUT
BNC type ×1
Black burst
0.286 Vp-p (DSR-1600A) or 0.3 Vp-p
(DSR-1600AP), 75 Ω, negative sync
Composite sync
VIDEO OUT 1, 2 (SUPER)
BNC type (×2), composite, 1.0 Vp-p,
75 Ω, sync negative
COMPONENT VIDEO OUT
BNC type (×3), Y/R−Y/B−Y
Y: 1.0 Vp-p, 75 Ω, sync negative
R−Y: 0.7 Vp-p, 75 Ω (75% color bars
for DSR-1600A or 100% color bars for
DSR-1600AP)
B−Y: 0.7 Vp-p 75 Ω (75% color bars
for DSR-1600A or 100% color bars for
DSR-1600AP)
S VIDEO OUT DIN 4-pin
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.286 Vp-p (DSR-1600A) or
0.3 Vp-p (DSR-1600AP), 75 Ω (burst
level)
Analog audio outputs
AUDIO OUT XLR 3-pin, male (× 4), +4/0/−3
600 Ω loading, low impedance,
balanced
AUDIO MONITOR OUT
Phono jack, 47 kΩ, unbalanced
−∞ to −11 dBu ±1 dBu, −20 dBFS
(DSR-1600A)
−∞ to −9 dBu ±1 dBu, −18 dBFS
(DSR-1600AP)
* Selectable on DSR-1600AP only
*
/−6 dBu,
67
Specifications