Table of Contents
Advertisement
1-5.
TUNING
THE
TV AND
THE
RECORDER
1-5-1. TV ADJUSTMENT
First, adjust your TV receiver so that it is tuned to the signals from
the recorder.
@ Press
the
ON/STANDBY
button
of the
recorder
to turn
the
recorder on.
TEST SIGNAL
ON
ON/STANDBY button
@ Open the tuning compartment
lid and set the TEST SIGNAL
switch to ON.
® Turn on the TV and select a channel on the TV which is not used
to receive a TV station. Tune the channel until you see a clear black
and white pattern on the TV screen
and you hear a high-pitched
tone. This is the recorder's test signal.
— If all the channels on your TV are used for receiving stations, select
the channel you watch least.
—
If you are not sure how to tune your TV, please refer to the TV's in-
struction manual or consult your dealer.
Recorder's test signal
@ if the test picture is free of disturbance, set the TEST SIGNAL
switch to OFF.
If the test picture is not free of disturbance
There might be interference. To receive the recorder's signal
on your TV without interference, proceed as follows:
@ Reset the TEST SIGNAL switch in the tuning compartment
to OFF.
You will probably see interference or perhaps even a TV pro-
gramme on the TV screen.
@ Adjust the channel of the TV to a channel between UHF E30
and E39 with the tuning control or the fine tuning control on
the TV, so that the TV screen shows only "snow" and so that
all you can hear is a steady rustling sound.
© Set the TEST SIGNAL switch to ON again.
@ Slowly turn the RF CHANNEL
screw on the back of the
recorder until you see an undistorted test picture on the TV
screen.
You can use the adjustment tool located to the right of the RF
CHANNEL screw hole to turn the screw.
© Reset the TEST SIGNAL switch to OFF.
Now your TV receiver is tuned to the recorder. Whenever you use
the video recorder, you should set the TV to the channel
which you
have chosen above.
Adjustment tool
Advertisement
Table of Contents
