Xerox iGen Series User Manual page 17

2. Set the Cart to the appropriate height.
a. Locate the line on the cart post that corresponds to the stacker height (low: 210 mm;
high: 600 mm).
b. Press the upper or lower part of the elevation button to raise or lower to match the short
lines on the sides to the line on the cart post.
Low position
Line up pointer to hole
3. Line up the Cart tines with the XPS tines.
Low position
4. Align the colored tine with the arrow on the XPS Stacker.
Operating the Xerox Production Media Cart (Nuvera)
High position
Line up pointer to hole
High position
Xerox Nuvera, iGen Production System Production Media Cart
Production Media Cart User Guide
13