Pre-Operation Inspection - Xerox iGen Series User Manual

Safety Warnings

Always look in the direction of travel.

Keep a clear view and when the load obstructs visibility, travel with the load lowered.

Watch swing clearance when turning near walls, racks, pillars, machinery, or other obstacles.

Before you leave the Cart, fully lower the paper table and set the caster locks.

Do not operate the Cart at greater than 3 miles per hour.

Never stand or sit on the paper table.

Never sit, stand, lift, or transport any person on the paper table.

Never use the Cart as a stepladder.

Never operate the Cart on a moving vehicle.

Never operate the Cart when any of its parts have been removed.

Do not wear loose clothing such as ties and scarves, or dangling accessories such as
bracelets, when operating the Cart to avoid entanglement.

Tie back long hair during operation to avoid entanglement.

Never use or store the Cart in wet environments.

Do not allow any part of the Cart to get wet.

Never exceed the Cart load capacity of 160 lb. (72.6 kg) to avoid personal injury and
damage to the Cart.

Never raise or lower the paper table unless the Cart is on a firm, level, even surface and the
casters are in the locked position.

Never use shims or other objects to level the Cart.

Use extreme caution when raising or lowering the paper table when it is near other objects
to avoid personal injury or damage to other objects.

Never allow any object, including limbs, to go beneath the paper table to avoid personal
injury or damage to other objects as the paper table nears the bottom of its range.

Use caution when lowering the paper table to avoid personal injury or damage to objects
that may have come between the paper table and base of the unit.

Never operate the Cart when the edge of the paper stack is less than 1 inch (25 mm) from
the front (loading edge) of the paper table. Keep the stack closer to the vertical post.

Never tilt the Cart when a paper stack is loaded.

Pre-operation Inspection

Workplace safety regulations require that the Production Media Cart (Cart) be inspected before
each shift.
Follow the inspection point list below to complete this check. If anything is found to be wrong
with the Cart, then it must be taken out of operation. Do not use a Cart which fails this
inspection.
6 Xerox Nuvera, iGen Production System Production Media Cart
Production Media Cart User Guide