Programming The Remote To Control Volume Level; Replacing Batteries In The Remote - Sony Cablevision DHG-M55CV Hardware Setup Instructions

Programming the
Remote to Control
Volume Level
Replacing Batteries
in the Remote
If the component does NOT respond
Try programming the remote using the other codes listed for your
brand. If you still cannot get your component to respond after trying
all the codes, your component may not be compatible with this
remote. If this happens, you must use your component's remote to
operate it. Or, as an alternative, you can use the following
instructions to program the Digital Network Receiver's remote to
control the volume level.
If you cannot successfully program the Digital Network Receiver's
remote to control your TV (as described on page 6), you can still use
this remote to control the volume level (and
the Digital Network Receiver's audio
To program the remote to control the volume level
1
Press the
CODE SET
2
Enter using the 0-9 buttons.
200
3
Press the button (located below the "
#
To check if the code works
1
Aim the remote control at the Digital Network Receiver.
2
Press the
VOL+, VOL-,
you're done.
If you replace the TV or purchase a new one
Try programming the remote control as described on page 6, or you
can continue to control only the volume level as described in this
section.
When the batteries need to be replaced, insert two size AA batteries
by matching the + and
battery compartment.Then replace the battery compartment lid.
✍
Remove the batteries to avoid damage from possible battery leakage whenever you
anticipate that the remote control will not be used for an extended period.
Handle the remote control with care. Avoid dropping it, getting it wet, or placing it in
direct sunlight, near a heater, or where the humidity is high.
Using the Remote Control (RM-Y806)
LINE OUT 1 (TV)
button.
9
or button. If the volume level responds,
MUTE
on the batteries to the diagram inside the
–
) that is output from
MUTE
and jacks.
TO TV/VCR
" button).
7