Fdm Single 3D Print; Install Fdm Toolhead - EcubMaker TOYDIY 4in1 Manual

FDM single 3D print

--------------------------------------------------------------------------------------------------------------------------------------------

1.Install FDM Toolhead

(1) Power up, if there are filament rest
in the Toolhead, please enter the option
Filament>Unload Filament at first to exit the
consumables, otherwise it will be easy to
plug in.
(2) Confirm the current Toolhead type on the
screen. If it shows the FDM Toolhead, jump
straight to step 4. If it shows other Toolhead,
proceed to step 3.
(3) Use Menu Button, enter Utility > Change
ToolHeader > Change To FDM Toolhead,
browse the contents displayed on the screen
and click To the last step.
(4) Loose the ToolHead Screw fixing the
current Toolhead, remove the original
Toolhead upward but keep the cable
connected. Remove it and put it aside. Pay
attention not to unplug the cable at this
moment.
------------------------------------------------------------------------------------------------------------------------------------------
19 B EcubMaker TOYDIY basic setup and installation