Connecting The Mpx 423 A Matrix Switcher - Extron electronics MPX 423 A User Manual

im Vertrieb von
Installation, cont'd
12
13
14
15

Connecting the MPX 423 A Matrix Switcher

The MPX 423 A matrix switcher can be connected to as many as 12 input devices
simultaneously, and can output to as many as six devices simultaneously, or one at
a time.
Follow the steps below and see the installation example in figure 2-4.
1
2
3
4
5
6
7
8
9
www.camboard.de
2-4 MPX 423 A • Installation
CAMBOARD Electronics
RS-232 — One female DB9 connector for a host computer or third party
controller using Extron's Simple Instruction Set (SIS) or Windows
Software.
LAN Activity LED — A blinking yellow LED indicates LAN activity.
LAN connector — Plug an RJ-45 jack into this socket to connect the unit to a
computer network. Use a straight-through cable to connect to a switch, hub,
or router.
Link LED — The green LED lights to indicate a good LAN connection.
Reset button — A recessed button that allows for a manual reset using a
Extron Tweeker, pointed stylus or ballpoint pen. The unit can be reset to five
modes (see Resetting the Unit in chapter 3 for additional information).
Reset LED — The green LED flashes to show the reset mode indicators and
that power is on (see Resetting the Unit in chapter 3 for additional information).
Turn off power to the MPX 423 A matrix switcher and all other devices that
will be connected.
If the MPX 423 A matrix switcher is to be rack, table or furniture mounted,
position the brackets and insert the mounting screws. See the Mounting the
Matrix Switcher, earlier in this chapter.
Attach up to four VGA, four composite video, and four S-video, input devices
to the MPX 423 A matrix switcher.
Connect the switcher's VGA, Video (composite), and S-video outputs (up to
six, two of each video format) to the inputs of the display(s).
For audio input, connect up to 12 audio sources to the switcher's audio inputs
of the VGA, Video (composite), or S-video groups (up to 4 for each group).
See figure 2-4 for a connection diagram.
For audio output, connect an audio output device to each of the two audio
outputs. See Audio outputs in chapter 3, Operation for wiring diagrams.
If the MPX 423 A matrix switcher is to be connected to a computer or host
controller for remote control, connect the host's RS-232 cable to the 9-pin
female RS-232 connector of the MPX unit. For an RS-232 pinout table, see the
RS-232 and Ethernet Control later in this chapter.
For an Ethernet connection, plug one end of a Cat 5, straight-through Ethernet
cable to the RJ-45 LAN port of the switcher. See RS-232 and Ethernet Control
later in this chapter for pinout instructions.
Power up the input and output devices, then connect power to the rear AC
connector of the MPX 423 A matrix switcher.
Tel. 07131 911201
Fax 07131 911203
® Control
ce-info@camboard.de