Specifications - Sony STR-D560Z Operating Instructions Manual

Additional Information

Specifications

AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8-ohm load, both
channels driven, from 20 -
20,000 Hz, rated 100 watts
per channel, minimum RMS
power, with no more than
0.09% total harmonic
distortion from 250
milliwatts to rated output
(USA model only).
Amplifier section
POWER OUTPUT
Stereo mode (8 ohms 20 Hz - 20 kHz,
THD 0.09%)
100 W + 100 W
Surround mode (8 ohms at 1 kHz, THD
0.8%)
Front: 100 W/ch
Center*: 100W
Rear*: 100 W/ch
* Depending on the sound
field settings and the
source, sound will not be
output.
5.1/DVD mode (unavailable on STR-DE915)
(8 ohms at 1 kHz, THD
0.8%)
Front: 100 W/ch
Center: 100W
Rear: 100 W/ch
Dynamic power output
155 W + 155 W, 8 ohms
220 W + 220 W, 4 ohms
Harmonic distortion at rated output
Less than 0.09% (with
DIRECT PASS on)
Frequency response
PHONO: RIAA
equalization curve
±0.5 dB
CD, TAPE, DAT/MD,
VIDEO 1, 2,:
10 Hz - 50 kHz
DIRECT PASS on)
32
Inputs
Sensitivity
PHONO
2.5 mV
CD (STR-
150 mV
DE915)
CD (other
200 mV
models)
TAPE, DAT/MD,
VIDEO 1, 2, 3
(STR-DE915
150 mV
only),
LD/DVD,
TV/DBS
LD/DVD
AC-3 RF
—
(STR-DE915
only)
LD/DVD, CD,
DAT/MD
—
OPTICAL
(STR-DE915
only)
5.1 INPUT
(Unavailable
200 mV
on STR-
DE915)
Outputs VIDEO 1, 2 AUDIO OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
WOOFER:
Voltage: 2 V
Impedance: 1 kilohms
PHONES:
Accepts low and high
impedance headphones
BASS BOOST STR-DE915: +6 dB at 50 Hz
STR-DE715/DE615/D660Z/
D560Z: +10 dB at 70 Hz
TONE (unavailable on STR-DE915)
±8 dB at 100 Hz and 10 kHz
Digital signal processor section
(STR-DE915 only)
Modulation (A/D conversion)
High Density Linear
Converter
Demodulation (D/A conversion)
High Density Linear
Converter (Advanced
pulse D/A converter)
Sampling frequency
48 kHz
+0.5
dB (with
–2
Surround
S/N
(weighting
Impedance
network,
input level)
50 75 dB*
kilohms (A, 2.5 mV)
50 82 dB*
kilohms (A, 150 mV)
100 dB
(A, 20 kHz,
75
LPF)
100 dB
(A, 20 kHz,
—
LPF)
Equalizer
50 82 dB*
kilohms (A, 150 mV)
* '78 IHF
FM tuner section
Tuning range
Antenna terminals
Sensitivity
Usable sensitivity
S/N
Harmonic distortion at 1 kHz
Separation
Frequency response
Selectivity
AM tuner section
Tuning range
LFE MIX:
MUTE, –20 - 0 dB, 0.5 dB
step
D. RANGE COMP:
OFF, 0.1 - 0.9, STD, MAX
REAR level:
–20 - +10 dB, 0.5 dB step
CENTER level:
–20 - +10 dB, 0.5 dB step
SUB WOOFER level:
–20 - +10 dB, 0.5 dB step
EFFECT:
21-step adjustable
WALL:
17-step adjustable
SEAT F/R:
17-step adjustable
SEAT L/R:
17-step adjustable
REBERB time:
17-step adjustable
Depending on the sound
field, some parameters
may not be adjustable (see
page 26).
BAND: BASS/TREBLE
Turnover frequency:
Bass: 99 Hz - 992 Hz
Treble: 1.0 kHz - 8.6 kHz
Level: ±10 dB, 0.5 dB step
87.5 - 108.0 MHz
75 ohms, unbalanced
Mono: 18.3 dBf, 4.5 µV
Stereo: 38.3 dBf, 45 µV
11.2 dBf, 2 µV (IHF)
Mono: 76 dB
Stereo: 70 dB
Mono: 0.3%
Stereo: 0.5%
45 dB at 1 kHz
+0.5
30 Hz - 15 kHz dB
–2
60 dB at 400 kHz
With 10 kHz interval:
530 - 1710 kHz (USA and
Canadian model only**)
530 - 1610 kHz (models for
all other countries except
for Australia)
With 9 kHz interval:
531 - 1710 kHz (USA and
Canadian model only)
531 - 1602 kHz (Australian
model and models for all
other countries**)