2. Set the monitor type selection switches on the computer's back
panel correctly for your monitor type. You must do this before you
connect the monitor.
For EGA monitor use, leave the switches at the factory setting. If
you are using a color or monochrome monitor, modify the switch
settings according to the table below. T he up position is OFF; the
down position is ON.
Monitor Switches
EGA Monitor
Color Monitor
Monochrome Monitor
Warning: To prevent damage to your monitor, you MUST set the
switches correctly for your monitor type BEFORE you connect the
monitor and switch on the system.
3. Set the monitor on top of or beside the computer. Plug the moni
tor's video cable into the jack labeled "Monitor" on the back of the
computer. Make sure the monitor is turned off, then connect its
power cable to the monitor, then to a grounded electrical outlet.
See the manual supplied with your monitor for further information.
\_
_ __
To Power
t
-�-
c:::a
7
Switch 1
Switch 2
ON
OFF
ON
OFF
ON
OFF
--------
- Video Cable
.J
�
.. _i=i.,,oOC
�
c=:=
_n_
Switch 3
Switch 4
OFF
OFF
ON
Back of Monitor
J
Back of Compute r
,.:· . . .
c:::::.
OFF
ON
ON