Ingersoll-Rand SSR UP5-4 Operation And Maintenance Manual page 16

14
INSTALLATION / HANDLING
KEY
A Valve, receiver relief
B 1/2" N.P.T. drain port for optional EDV–2000 auto condensate drain
valve
C Yellow stand–by light
D Green power–on light
E Green start push button
F Emergency stop button
G Starter box
H Gauge, pressure
I Motor
J Filter, air inlet
K Cartridge, coolant separator
L Filter, coolant
NOTES
1. Coolant (lubricant) fill quantity (approximate) 1.2 US gallons (4.5
liters)
2. Recommended clearance in front of control panel door 42 inches
(1067 mm) or minimum as required by the latest national electrical
codes (NEC) or applicable local codes.
3. Recommended clearances on left and right sides 36 inches
(914mm)
4. Minimum recommended clearance for the rear of the compressor
is to be 36 inches (914mm ).
5. External piping shall not exert any unresolved moments or forces
on the unit. Use pipe size as large or larger at discharge connection.
6. There should be no plastic or pvc piping attached to this unit or used
for any lines downstream.
7. Do not pipe into a common header with a reciprocating compressor,
unless the reciprocating compressor utilizes a discharge pulsation
damper.
8. Sizing of electrical components not supplied by Ingersoll Rand is the
responsibility of the customer and should be done in accordance with
the information on the compressor data plate and national and local
electrical codes.
en
M Valve, ball
0.75"
N 4 slots 17.5 (0.68) x 44.5 (1.75)
O Air receiver
(Dia. 620.0 x 1168.4 LG) (Dia. 24.40" x 46.00" LG)
P Compressor and cooling air intake
Q Cooling air exhaust
R Valve, airend relief
S Plug, coolant filler
T Sight–glass
U Plug, coolant drain
V Lifting points
W Valve, pilot
X Switch, pressure
NOTE
All dimensions are in millimetres (inches) unless otherwise stated.
Ensure that the correct fork lift truck slots or marked lifting points are
used whenever the machine is lifted or transported.
UNPACKING
The compressor will normally be delivered with a polythene cover.
If a knife has to be used to remove this cover ensure that the exterior
paintwork of the compressor is not damaged.
Ensure that all transport and packing materials are discarded in a
manner prescribed by local codes.
http://air.irco.com