Table of Contents
Advertisement
2.1.5 Environmental criteria
Please observe the ambient temperature of the application in use because certification is
valid for temperatures between – 20°C --- + 50°C. Please see type label of the product for
further data. If the equipment is used in other temperatures than mentioned the safety can not
be guaranteed.
Selection and use of equipment is always under the responsibility of the operator.
Please note that all of the aforementioned criteria are to be passed when selecting the
equipment.
Please do not take any unnecessary risks.
Operating instructions
3.1 Personnel
The use of the equipment is to be controlled and accepted by the operator. The personnel
using the unit have to be authorized by the operator or his representative. In case of further
training of using the equipment please contact the local supplier of this equipment.
3.1 Visual inspection of Slam® Trans
As for all equipment to be used inside explosion hazardous area it is recommended that
before taking the unit into Ex –area, a visual re-inspection on the unit was taken and an
analysis made the unit to be un-damaged and fully operational.
In case faults or defects on the unit are noticed, it is prohibited to take such a unit into Ex –
area until corrective actions have been made.
3.2 Special attention on 2-pole use (24 V or 42 V)
Using Slam® Trans -unit with 2-pole socket outlets (without earthing / bonding) imposes
certain extra requirements for the relating equipment. Please note that the relating equipment
should not have any external metal parts which may be a source of ignition because of static
electricity (ref. EN 60079-14). Extra bonding may be required for ensuring correct bonding.
Slam® range of products does include luminaries suitable for 2-pole use. Please ask us or
your supplier for further details.
10/16
Advertisement
Table of Contents
